9)
4.3
Shower Unit (Continued)
IMPORT ANT:
THE GAS COMPARTMENT VENTS MUST BE KEPT CLEAR OF
FOREIGN MATTER AT ALL TIMES AND SHOULD BE REGULARLY CHECKED FOR
BLOCKAGES OR DEBRIS. GAS BOTTLES MUST ONLY BE STORED AND USED IN
AN UPRIGHT POSITION.
IMPORTANT:
WHEN THE VEHICLE IS IN MOTION, THE SHOWER SLIDING
DOORS MUST BE OPEN AND SECURED BY THE TWO RESTRAINING STRAPS
THUS AFFORDING VISION THROUGH THE REAR WINDOW.
WATER HEATER
The Carver Cascade 2GE water heater is fitted inside the offside bed
box. Refer to the Carver Cascade water heater instruction leaflet for general information.
Operation instructions are to be found later in the manual.
10)
STORAGE
Storage is provided by cupboards, lockers, drawers, wardrobe and bed
boxes. Further space is available in the overcab area and pelmet storage bays. A storage
compartment is located behind the toilet and a locker with a lock below the passenger seat. Items
may also be stored underneath the drivers seat and cab door pockets.
IMPORTANT:
HEAVY ITEMS MUST NOT BE STORED IN ANY OVERHEAD
LOCKER OR CUPBOARDS, OR IN ANY STORAGE AREA FROM WHICH THEY
COULD COME FREE AND CAUSE INJURY TO THE OCCUPANTS OF THE VEHICLE.
ENSURE ALL CUPBOARDS ARE SECURELY FASTENED BEFORE MOVING OFF.
IMPORT ANT:
AEROSOLS AND HIGHLY FLAMMABLE MATERIALS MUST
NOT BE STORED IN ANY COMPARTMENT BEHIND, OR ADJACENT TO, ANY
HEATER OR HEAT SOURCE.
11)
SLEEPING ARRANGEMENTS
Trophy is designed as a two berth model, offering the choice
of either two single beds, each running longitudinally down the length of the vehicle, or
alternatively a double bed, also running longitudinally down the length of the vehicle.
a)
Sin�le Beds
Offside
a)
Move drivers seat fully forward.
b)
Remove arm rest from slides, reverse and lay flat, cushion upwards in gap between
forward end of settee base and base of drivers seat backrest.
Nearside
a)
Swivel passenger, if necessary, to forward facing position.
b)
Slide passenger seat fully forward.
c)
Release press studs holding backrest to wall of unit.
d)
By releasing lock (at rear base of bed box, adjacent to gangway) slide seat
assembly to inner position.
e)
Release lock, positioned at top of drop down flap, and slide bed mechanism fully
forward, at the same time raising the hinged flap, so as to the flat on the rear of the
nearside cab.seat box.
f)
Place small infil cushion, stowed in the overcab locker in gap adjacent to forward
end of sink unit with tapered side of cushion facing out.
g)
Place medium sized buttoned infil cushion stored in the nearside underseat
locker, on top of hinged plastic panel between passenger seat backrest and forward
base cushion.
Содержание 1993 Trophy
Страница 1: ...Auto Sleeper INSTRUCTION M A N U A L ...
