5.16
16)
WINTERIZATION OF THE WATER SYSTEM
Water Heater
IT IS MOST IMPORTANT THAT THE WATER HEATER IS DRAINED IN ORDER TO
A VOID THE DANGER OF FROST DAMAGE.
To drain the heater:
1.
Ensure that the gas, 12 volt and 240 volt electrical supplies are turned off.
2.
Switch off the water pump.
3.
Open the hot and cold water taps in the sink and shower compartment.
4.
Remove the drain plug fitted in the heater. This is the large slot-headed plug in the bottom
lefthand comer of the outside cowl. When doing this care should be taken not to loose the
small rubber 'O' ring that seals the drain plug.
5.
When the heater is empty the drain plug and 'O' ring should be replaced. (Please note that it
takes a considerable length of time to drain the water heater).
Water System
The remainder of the water system should be drained by:
1 .
Emptying the fresh water tank by opening the stop tap fitted in the rearmost face of the
tank.
,,
Opening the hot and cold water taps in the sink and shower compartment.
3.
Turning on the water pump.
4.
After water has ceased to flow out of the hot and cold water taps the cassette toilet should
be flushed until there is no more water.
5.
Tum off the water pump and stop tap in the rear of the tank.
6.
Empty the chemical toilet cassette.
NOTE: IT IS IMPORTANT THAT WHEN THE WATER SYSTEM IS DRAINED THAT
THE SINK AND SHOWER TAPS ARE LEFT IN THE OPEN POSITION.
Содержание 1993 Trophy
Страница 1: ...Auto Sleeper INSTRUCTION M A N U A L ...
