Electrical Control Panel (Continued)
Appliance
Carver Cascade 2GE Water Heater
240 volt AC light (RL9/4)
Electrolux Refrigerator RM4217 (12v)
Electrolux Refrigerator RM4217 (240v)
13 amp sockets
240 Volt AC fuse switch (Cascade)
5. l l
Loadin�
660 watts
=
8 watts
=
95 watts
=
95 watts
=
NIA
up to 10 amp
NIA
2.75 amps
0.03 amps
7.9 amps
0.40 amps
li.JlJ.f.: rhe 13 amp sockets are protected by the 10 amp MCB, all other mains appliances are
protected by the 5 amp MCB.
The electrical control panel incorporates the following additional facilities:
1)
Battery Condition Indicator Li�hts In order to check the battery condition, press the
water gauge button (READ) and the battery condition indicator lights will illuminate.
Readings should be interpreted as follows:
1)
Green
-
Battery is fully charged- 12 to 14 volts.
2)
Red
Battery requires recharging - level has reached 12 volts or below and
recharging should take place as soon as possible.
2)
12 volt Master Switch
This may be used to isolate the caravan electrical system
except the refrigerator 12 volt system which operates independently through the vehicle
ignition switch.
3)
Water Pump Master Switch This may be used to isolate the water pump. It should be
switched off when the water pump is not in use. (Failure to do so will cause the pump to
"hunt" intermittently- caused by the PRY re-asserting itself at regular intervals).
4)
Water Level Indicator
In order to check the water level in the fresh water tank,
press the "push" button which will give an illuminated reading on the dial showing the
state of the water level. In order to calibrate the gauge, fill the water tank fully. then press,
and hold, the "read" button setting the indicator to the "full" position.
IO
BATTERY/SECOND BATTERY
Both the main vehicle battery and second battery are fused with a 20 amp blade fuse. It should be
noted that this fuse protects the 12 volt circuit to the control panel and caravan electrics only. This
fuse is fitted adjacent to the positive terminal of the vehicle battery/second battery. on a fuse
terminal block. A 30 amp fuse is fitted, in a terminal block, between the main vehicle battery and
the second battery in order to protect against overloading of the second battery charging system.
IMPORTANT: THESE FUSE RATINGS MUST BE ADHERED TO WHEN
REPLACEMENTS ARE NEEDED.
,
Содержание 1993 Trophy
Страница 1: ...Auto Sleeper INSTRUCTION M A N U A L ...