125
Erase Codes
After reading the retrieved codes from the vehicle and certain repairs have
been carried out, you can decide to erase the codes from the vehicle using
this function. Before performing this function, make sure the vehicle
’s ignition
key is in the ON (RUN) position with the engine off.
To erase codes
1. Tap
Erase Codes
from the Function Menu.
2. A warning message displays to advice of data loss if this function is
completed.
a) Tap
Yes
to continue. A confirming screen displays when the
operation is successfully done.
b) Tap
No
to exit.
3. Tap
ESC
on the confirming screen to exit Erase Codes.
4. Perform the Read Codes function again to check if codes have been
erased successfully.
Live Data
When this function is selected, the screen displays the data list for the
selected module. The items available for any control module vary from one
vehicle to another. The parameters display in the order that they are
transmitted by the ECM, so expect variation between vehicles.
Gesture scrolling allows for quick movement through the data list. Use one or
two fingers to swipe the screen up or down to locate the data you want. The
figure below shows a typical Live Data screen:
