OPERATING INSTRUCTIONS CHECKLIST
cont...
11.
Prior to operating the appliance check for dust or particles lying on top of the
burners. Refer Page 10.
12.
Check and verify that logs are placed correctly as per instructions on
Pages 8-11 of this Installation Manual. If logs are incorrectly positioned or
placed wrongly it can create a hazardous situation, and in most instances, the
heater will not operate correctly.
13.
Do not light heater without logs fitted, as heater will not operate.
14.
For your personal safety, check and verify that polarities are correct in the
power supply to the heater. Also check for proper earth connections at the
power source. If polarities in power supply are incorrect, change the polarities
in the power supply to heater, NOT in the heater cord. Incorrect polarity’s
will cause the appliance not to function correctly.
15.
Check and verify prior to starting up the appliance, that all panels are secured
in place and that the main door has been locked in position.
16.
After verifying and checking all the above points proceed to lighting
instructions. Refer page 31.
30
PLEASE NOTE: IS700 MODEL “COLD START”
It will take anywhere from one to two hours or more for the front burner to fully
carry. It may be necessary to start the front burner only and let it run for 20 minutes
or more to correctly flame sense. After this is achieved, the rear burner can be
switched on. This procedure may be required depending on the flue type, length and
gas type. The front burner is longer than the rear, so it will take longer to carry and
track.
PLEASE NOTE: PUMP CONTAINER
When the pump container is dry, you may hear popping and rumbling sounds com-
ing from the container itself. This may come and go depending on the water levels
and condensate rate, which is a normal operation of the heater.
