Aumuller SP 8 Series, Руководство по сборке, Страница: 20 / 36

Page
20
of
34
9000002601.doc Assembly Instructions
•
Spindle Drive SP -24 V / 230 V
The selection of appropriate fasteners is an important prerequisite for the safe and proper
operation of drives on power-operated windows. Only use specified fasteners!
Check before start of assembly which fasteners of size 6 can be used!
All clamping and mounting screws shall be checked for tight fit and must be re-tightened, if necessary.
We recommend using thread-locking compound (e.g. Loctite) to secure the fasteners against loosening due to vibrations
caused by moving of the casement via drive.
In case of doubt please consult the window manufacturer and/or the drive supplier.
Recommended fixings and Fasteners
Wood
of size M5 or ST4.8
ISO 4762, ISO 4017
ISO 7049, ISO 7085
DIN 7500
Thread /,
self-tapping /
or sheet-metal screws
such as:
Cylinder head with
hex socket, internal
serration (Torx),
Phillips or external
hex head
Blind rivet nut
size M6 e.g. with
knurled countersunk
head
with head type
Steel / high-
grade steel UPVC
(Plastic)
Window profile - examples
Specified fasteners
Mounting examples
Sheet-metal screws
or self-tapping screws
Metric screws with
blind rivet nuts
Thread /,
self-tapping /
or sheet-metal screws
such as:
Cylinder head with
hex socket, internal
serration (Torx),
Phillips or external
hex head
Blind rivet nut
size M6 e.g. with
knurled countersunk
head
with head type
of size M5 or ST4.8
ISO 4762, ISO 4017
ISO 7049, ISO 7085
DIN 7500
Metric screws with
blind rivet nuts
Sheet-metal screws
or self-tapping screws
Wood screws
size 6
DIN 96
DIN 7996
DIN 571
Secure screws
against loosening
by adding wood
adhesive
Recommendation
such as:
round head with slot
round head w. cross
or hex head
or special type
with head type
Aluminium
Wood screws
Screws for plastic
such as:
round head with
cross or
external hex head
or special form
with internal
serration
with head type
size 6 or
sheet-metal screws
ST4.8
DIN 95606
DIN 95607
ISO 7049
ISO 7085
DIN 7500
Screws for plastic
(if possible, screw through
two cavity webs)
Sheet-metal screws or self-
tapping screws (screwed into
steel cavity reinforcement)
The use of appropriate screws depends on the window material and on the formation and thickness of the profile. It also depends on
the forces that are applied to the window by the drives. Depending on the profile system different fasteners may be suitable.
This must be checked prior to assembly.
K
F
A
K
F
F
K
K
F
K
F
F
K
K
F
14
CAUTION