Aumuller SP 8 Series, Руководство по сборке, Страница: 11 / 36

Assembly Instructions
•
Spindle Drive SP -24 V / 230 V 9000002601.doc Page
11
of
34
Pre-assembly Checks
Checking Installation Requirements
Depending on the place of installation / type of window and
on the real structural conditions there are different installa-
tion requirements for the drives.
They are obtained from the special installation sketches
and/or planning drawings and have to be checked accord-
ingly.
Generally the following should be checked first of all:
- Are the supporting surface and the structural conditions
adequate for the load transfer?
- Does the installation level require an additional supporting
structure?
- Is there enough space for the pivotal motion of the drive?
- Have sufficient measures been taken to avoid thermal
bridges (thermal separation) at the application points?
If not, the operator must be notified of these require-
ments!
Information on the Load Transfer
of the drives to the window profiling:
The supporting surface of the brackets and casement
brackets must fully rest on the window or frame profile,
respectively.
Tilting movements of the mounting elements
when the spindel moves out are not allowed. Safe and firm
mounting on the window profile must be ensured.
Insert underlay plates / brackets, if necessary.
It is absolutely essential to take the drive tilting
range into consideration. If this cannot be ensured,
find mounting alternative or another type of drive.
5
Important instructions for safe assembly! Fully observe all
instructions! Incorrect assembly may lead to serious injuries!
230 V
24 V
Tandem operation
(no synchronized)
Influence of forces other
than push or compression
F
outside
inside
Tilting range
Supporting
surface of bracket
Supporting
surface of bracket
Structural factors
(obstacles)
e.g. jamb
!
WARNING
Storage of the drives on site prior to the assembly
Protective measures against damage, dust, humidity or
contamination (for example caused by covers, film or card-
board packaging) must be taken.
Only store the drives in dry and well ventilated places be-
fore installation.
Testing the drives prior to installation
We recommend checking the drives prior to installation for
their good mechanical condition and completeness.
Drives must run easily in both directions. We recommend
the use of our test kit for drives in 24 V DC / 230 V AC
(part no.: 533981).
Never install and operate damaged
products. Any damage must be
reported immediately to the
supplier / manufacturer.
Drives must always be tested on
a non-slip and stable surface or in
a test fixture.
During trial operation there should be no physical contact
with the extending spindle.
Instructions on Intended Use
Ensure that the use of the drives is in accordance with the
specified range of application / area of application. Any
other use of the products causes loss of warranty.
The end-user must be informed about the intended use of
the drives.
In particular, it must be pointed out to the end-user that -
apart from pressure and tensile forces in opening / closing
direction - no additional forces
may impact on the drive
spindle.
Additional warning signs might be required.
Determining required safety measures in
accordance with MD 2006/42/EC
A risk assessment must be carried out in order to determine
any required safety measures. Furthermore the
operator must be notified of the remaining risks.
(Separate documents are available from
Aumüller Aumatic GmbH).
Predictable Misuse
It is absolutely essential to avoid any foreseeable misuse of
the drives!
Some examples: