Aumuller FVM2, Инструкции по сборке и пусконаладке

Страница: 19 / 32

19
Assembly Instruction
FVM2
06
Mounting options of the locking plate
locking plate: assembly below locking plate: assembly top
During start-up the 24 V-control voltage may
be switched on only:
• with opened casement
• unhinged opening drive
Only opening drives with internal load depen-
dent cut-off switch (
S3 / S12 ) may be used.
!
!
Test run: Opening drive

Switch on t he control voltage at the opening drive .

Move opening drive in CLOSE direction.

Move opening drive in OPEN direction and ensure the
ease of movement of casement.
Assembly locking drive FVM2
DIP switches setting

In a voltage-free state: Set the DIP switches

correctly, when not mounted the locking drive FVM2
(see chapter: „DIP
SWITCHES SETTING
: M
OVING DIRECTION AND THE
LOCKING STROKE
“).
A
SSEMBLY WITH
M-COM

Unhinge the opening drive.

Switch off the control voltage from the opening
drive.
I
NSTALLATION STEP
5
A
:
Assembly opening drive

Mount opening drive (see separate „Assembly and
Commissioning Instructions“ for each drive).

Make the connection for the control voltage to the
opening drive (see chapter: „E
LECTRIC CONNECTION
“).
opening drive Locking point
from
locking pin
locking bar
On-site assembly: locking plate

Possibly mount the locking plate

on-site conditions
- as described below:

Untighten the countersunk head srews

.

Mount locking plate

and base plate

on the locking
drive FVM2 according to site requirements.

Firmly tighten with countersunk screws

(4 Nm).
A
SSEMBLY WITH
M-COM
- L
OCKING DRIVE AND OPENING DRIVE
FVM2
The locking pin of locking bar must be
centered in the mounting slot of the locking
plate

.
locking bar 4 N/m
1
2
3
FVM2
4 N/m
locking pin
!
y y
2 1
FVM2
Factory settings
Test run: locking drive FVM2 (when not mounted)

Make the connection for the control voltage to the
locking drive FVM2 (see chapter: „E
LECTRIC CONNECTION
-
I
NSTALLATION
S
TEP
7
A
“).