13
Setting up Aulisa GA1001 System
Use the following procedure to set up the Aulisa GA1001 System:
It is recommended to charge the Infant Oximeter Module fully prior to
setting up Aulisa GA1001 System as it takes around 3 hours to fully
charge.
(See “Powering and Charging” section on page 27 for more
information.)
1. Turn on the Infant Oximeter Module by removing it from the wireless
charging case.
NOTE: The Infant Oximeter Module will turn itself on automatically when
The wireless charging case is opened.
NOTE: The power LED will light green when the power is ON.
2. Connect the GA-CD0002 Charging Adaptor- Display Unit to the
Display Unit and a power outlet.
3. Press and hold the power On/Off button for at least three (3) seconds
to turn on the Display Unit.
CAUTION! For long term monitoring (over 3 hours of
continuous use), the Display Unit must be
connected to the charging adaptor.
CAUTION! Do not plug adaptor into a switched outlet to
prevent accidental switching power off.
4. Select the correct timezone.
The MAIN screen will show up after
completion.
5. Wait for the wireless connection between the Infant Oximeter Module
and the Display Unit to be established.
(See “Device Pairing” section
on page 16 for more information.)
NOTE:
The Bluetooth connection status icon will turn blue once the
Infant Oximeter Module is paired with the Display Unit.
6. V
erify System Operation. (See “Verifying System Operation” section on
page 17 for more information.)
7. Attach the adhesive patch onto the back of the Infant Oximeter Module
following the instructions below.
