ADVANCED MANUAL / bit Ten D /
39
This section details the output levels of the
bit Ten D
channels as displayed by the software. Please note the
description of each of the points marked with numbers in the image below.
By acting on one of the sliders belongings to the output channels, you can adjust the output level
(-40÷0 dB) for each channel. The sliders activate according to the output setup.
This area shows the output level of each single channel (-40÷0 dB), compared to its slider position.
If you click the
“Mute”
button, you can mute the corresponding output channels.
If you click the
“Mute”
button again, output will resume
If you click the
“Link”
button, you can simultaneously adjust all the
bit Ten D
output levels. If you click the
Link
button again, the function will be disabled.
By clicking on the
“Solo”
button the output channels, with the exception of the activated one, will be muted.
By manually clicking on the
“Solo”
button this function will be disabled..
By using the
“Volume”
slider, you can adjust the general system volume (-60÷0 dB).
By using the
“Sub Volume”
slider, you can adjust the Subwoofer output level (-12÷0 dB), if the system
features a Subwoofer.
Remark:
if installation includes a mono Subwoofer, the sensitivity
of its dedicated amplifier needs to be increased by +3 dB
compared to the rest of the amplifiers (see the “Amplifiers
Sensivity” chart). This empirical method takes many factors
into account and provides a better adjustment of the
“
Sub Volume
”.
WARNING:
the output level adjustment as detailed in
affects the system signal / noise ratio
(whistle / background hiss).
We recommend that you always set the
bit Ten D
output level high and the amplifiers sensitivity low, so that
the amplifiers will be less affected by noises / background hisses.
Unfortunately, a too high output level introduces clipping on the processor outputs, especially if equalizations
with high gain are applied. We therefore recommend that you proceed as follows:
a-
Set the amplifiers sensitivity level at the minimum (3-4 V RMS). If you have not already done it
( see 8.1.21)
.
b-
Balance the emission level of the system channels by moving the cursors paying attention to
maintain a mid level centered at around -20 dB. Turn the output volume to an acceptable listening volume
level.
8.13
OUTPUT LEVEL
Amplifiers Sensitivity (Volts)
Front / Rear
1.0 2.0 3.0 4.0
Sub (+3 dB
)
0.7 1.4 2.1 2.8
8
10
5
6
7
1
2
3
4
1
2
5
6
7
1
2
3
4
Содержание bit Ten D
Страница 1: ...www audison eu ADVANCED MANUAL Rev 1 1c ...
Страница 50: ...ADVANCED MANUAL bit Ten D 50 ...
