ADVANCED MANUAL / bit Ten D /
31
2.
Save Setup:
saves the entire
bit Ten D
configuration in a file
(e.g. “bitTenConfig.dip”) that you can load again to
the
bit Ten D
a second time through the
Load Setup
function.
This feature is available both in
TARGET
and in
OFFLINE
modes.
3.
FINALlZE to bit Ten D:
loads all the parameters selected while
configuring the
bit Ten D
into the internal memory, allowing it to
work without being connected to a PC.
When selecting the
Finalize to bit Ten D
function, the software
notifies you that the data previously saved to the
bit Ten D
will be overwritten.
-
Click
YES
to load the data.
-
Click
NO
to interrupt the process.
WARNING:
Before disconnecting the
bit Ten D
from the PC or each time that you exit the PC Software after
modifying the system configuration, always run the
Finalize to bit Ten D
procedure. If you do not follow
these instructions, all data entered will be lost and the device will use the previous settings.
4
Synchronize: PC -> bit Ten D, PC <- bit Ten D
These functions synchronize the PC with the
bit Ten D
.
If a dialog box like the one on the right appears, it means that for some reason
communication between the PC and the
bit Ten D
has been interrupted.
To restore the communication, click:
•
PC -> bit Ten D
. The PC loads into the
bit Ten D
the settings
that have been selected so far.
•
PC <- bit Ten D
. The PC loads the settings
that have been previously stored in the bit Ten D.
WARNING:
This operation cannot guarantee that data are always retrieved.
If, once you run it, the operation is not successful, you need to:
1.
exit the
bit Ten D
software;
2
. turn the
bit Ten D
off;
3.
turn the
bit Ten D
on;
4.
launch the
bit Ten D
software again.
Synchronization will be restored but the selected settings will be lost.
5
Check for updates:
connects to the web site
http://update.audison.eu
and checks if any software / firmware updates to the
bit Ten D
and DRC are available, in order to update the devices you are using
(see 9.3 - 10.4)
.
To perform this operation, your PC has to be connected to the internet.
6.
Update Firmware:
select to update the
bit Ten D
firmware
(see 10.3)
.
7.
Reset Default Answer:
restores the display of warning messages if they have been
disabled by checking
“Don’t show me again”
.
8.
Restore Factory Defaults:
entirely resets the
bit Ten D
back to its default settings,
cancelling all data previously saved in the processor.
9.
Credits:
shows information about the
bit Ten D
software in use.
10.
Exit:
exits the PC software.
8
Содержание bit Ten D
Страница 1: ...www audison eu ADVANCED MANUAL Rev 1 1c ...
Страница 50: ...ADVANCED MANUAL bit Ten D 50 ...
