28
Installation with PP-ISO cable
3
This side of the cable harness will be directly connected to the car´s battery. Therefore you have to
separate intended cable joints of the harness.
Yellow wire: +12 Volts wire for connecting the M 5DSP MK2 to the positive terminal of the car´s
battery.
Black wire: ground wire for connecting the M 5DSP MK2 to the negative terminal of the battery or
directly to the car´s chassis.
4
After separating the cable joints the unused open wire ends (
4
) have to be properly insulated with
tape or other appropriate material.
I
Power supply to the car´s battery. The +12 Volts wire and the ground wire have to be connected
or soldered up to the respective joints of the PP-ISO cable harness. Afterwards it is important to
insulate the two wires separately.
Fig. 4:
Direct power supply – requirement for operating in “HighPower” mode
3
4
I
