17
Dear Customer,
Congratulations on your purchase of this innovative
and high-qual ity MATCH product.
Thanks to more than 30 years of experience in
research and development of audio products this
amplifier sets new standards in the range of digital
amplifiers.
We wish you many hours of enjoyment with your
new MATCH M 5DSP MK2.
Yours,
AUDIOTEC FISCHER
General installation instructions for MATCH
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all installation
instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect the
battery’s negative terminal to prevent damage
to the unit, fire and / or risk of injury.
For a proper
performance and to ensure full warranty coverage,
we strongly recommend to get this product installed
by an authorized MATCH dealer.
Install your M
5DSP MK2 in a dry location with
sufficient air circulation for proper cooling of the
equipment. The amplifier should be secured to
a solid mounting surface using proper mounting
hardware. Before mounting, carefully examine the
area around and behind the proposed installa-
tion location to ensure that there are no electrical
cables or components, hydraulic brake lines or any
part of the fuel tank located behind the mounting
surface. Failure to do so may result in unpredictable
damage to these components and possible costly
repairs to the vehicle.
General instructions for connecting the
M 5DSP MK2 amplifier
The M 5DSP MK2 amplifier may only be installed
in motor vehicles which have a 12 Volts negative
terminal connected to the chassis ground. Any oth-
er system could cause damage to the amplifier and
the electrical system of the vehicle.
Use only the enclosed cable harness or a PP-ISO
cable for connection of the M 5DSP MK2.
ATTENTION: Do not use the PP-ISO cable for
connection if the “HighPower” mode is activat-
ed.
The use of the PP-ISO cable in “HighPower”
mode or other cables can result in damage of
the equipment / wiring of your vehicle!
Prior to installation, plan the wire routing to avoid
any possible damage to the wire harness. All
cabling should be protected against possible crush-
ing or pinching hazards. Also avoid routing cables
close to potential noise sources such as electric
motors, high power accessories and other vehicle
harnesses.
The fuse may only be replaced by an
identically rated fuse (30 A) to avoid damage of
the amplifier.
Congratulations!
General instructions
