0611
Verifit User’s Guide Version 2.8
Page 105
21.11 REM speaker overdriven
FastFacts 21.11: REM speaker overdriven
21.12 Barcode scanner malfunction
FastFacts 21.12: Barcode scanner malfunction
REM speaker overdriven!
or
External REM speaker overdriven!
This message may occur on REM Directional or REM unaided or aided tests if:
v
No external front speaker is connected but one has been selected in Setup.
See
2.8: External display, printer, speaker
,
10.2: External REM speaker setup
.
v
No back speaker has been connected but a REM directional test is being
attempted. See
10.2: External REM speaker setup
.
v
The test environment is too reverberant for the distance between the client and
the speaker(s). Move the REM speaker(s), internal or external, and client away
from walls and hard objects. Move the client closer to the speaker(s).
v
The speaker or connecting cable (external speakers only) is defective. If this is
the case, you should not hear any sound coming from the internal or external
speaker(s) during any test. Try a different speaker or cable.
If there is no red scanning beam when the trigger is pulled, tug on the cable where
it enters the scanner. If it comes loose easily, push it back in until it clicks in place.
If the scanning beam stays on when the trigger is released or if the barcode
scanner fails to read known good barcodes, try the following:
1)
Unplug the scanner from the Verifit, then reconnect it. If the problem persists…
2)
Print this page on an external printer (see
2.8: External display, printer,
speaker
) or from the electronic user’s guide on the Verifit software CD (see
1.3: Electronic user’s guide
).
3)
Scan these two barcodes, starting with the top one. This will reset the scanner
to its default settings.
