Audion Elektro D 555 NH, Руководство пользователя

Страница: 4 / 28

4
1 To unpack the All-in sealer
Check during the unpacking of the All-in sealer if all parts mentioned below are present.
-
ALL-IN-SEALER D 555 NH.
-
Infeed guide
-
Rubber feet (4x)
-
Spare PTFE-belt (2x)
-
Wrench 10 / 13 to mount rubber feet
-
Screw driver to open front cover
-
Allan key (2x) gearbox
-
Manual
The D 555 NH is mounted on a wooden plate and packed in a carton box. The machine should be picked
up, out of the carton box, by two persons. Place the D 555NH on a work table. Disassamble the wooden
plate and mount the four rubber feet.
Check the data on the identification plate of the machine and record the information on the identification
plate (fig. 1) in the figure below.
The All-in sealer has been packed in a carton box. We recommend you to retain the carton box for future
transport.
2 Safety instructions
Read the manual carefully before any operation on the All-in!
−
Check, before the All-in is put into operation, whether the data on the identification plate corresponds
with the Voltage (V), Power Rating (W) and Frequency (Hz) of the local power supply.
−
If the All-in is not to be used for a long period of time, disconnect the power cord from the mains
supply.
−
Remove the power cord from the mains supply before any maintenance takes place on the All-in.
Beware of the danger of an electric shock.
−
Do not use water, abrasives, chemicals or other liquids for cleaning the All-in. See Chapter 8.
−
If in doubt about the correct operation of the All-in, immediately disconnect the power cord and consult
maintenance personnel.
−
Have repairs done by skilled maintenance personnel only.
−
Should liquid or an object fall into the All-in, immediately remove the power cord from the mains
supply and have the All-in checked by a skilled person before using it again.
−
Only use replacements parts provided by Audion Elektro.
−
Do not use the All-in to seal other materials then recommended by Audion Elektro (see chapter 3).
Fig. 1