AudioCodes MediaPack MP-40 series, Руководство пользователя

Страница: 155 / 180

User's Manual A. MediaPack Applications
Version 2.2 155 July 2007
A MediaPack Applications
This appendix provides step-by-step instructions for configuring the MediaPack for the
following typical applications in which the MediaPack can be implemented:
„
Connecting the MediaPack to a PBX (refer to Section ' Connecting the MediaPack to a
PBX ' below)
„
Lifeline and Fallback Setup (refer to Section ' Lifeline and Fallback Setup ' on page 163 )
„
Configuring FAX and Modem (refer to Section ' Configuring Fax and Modem ' on page
164 )
„
Configuring Supplementary Services (refer to Section ' Configuring Supplementary
Services ' on page 168 )
Note that this appendix is not intended to describe complete configuration settings. For
detailed information on the individual configuration options, refer to the relevant sections in
Chapter
6 .
A.1 Connecting the MediaPack to a PBX
This section provides a detailed description on how to connect the MediaPack to a PBX.
The line connecting between the PBX and the MediaPack can be configured either as a
Point-to-Point connection or a Point-to-Multipoint . In addition, the MediaPack can
connect to the PBX either as a Subscriber or a Trunk . As a result, the MediaPack has
four different operating modes to interconnect with a PBX. The PBX-MediaPack connection
options are summarized in the following table.
Table A-1: MediaPack-to-PBX Operating Modes
Connection Type
ISDN Layer 2 Mode
PBX Interface Type PBX
Port Uni-Side
MediaPack
Port Uni-Side
Point-to-Point Subscriber Network User
Point-to-Point Trunk User Network
Point-to-Multipoint Subscriber Network User
Point-to-Multipoint Trunk User Network
Note: When an ISDN port is configured as Network side, it means that this port
provides an ISDN network to which users connect. Conversely, when an
ISDN port is configured as User side, it means that this port serves as a
Phone/Terminal device and therefore, must be connected to an ISDN
network.