AudioCodes Mediant 8000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 424 / 924

Installation & Operation Manual 424 Document # LTRT-92224
Mediant 8000
8.
Confirmation Tone
9.
Call Waiting Tone

Tone Modulation Type
– The tone can be either Amplitude Modulated (1) or
regular (0).

Tone Form
– The format of the tone can be one of the following indices:
•
Continuous
•
Cadence
•
Burst

Low Freq [Hz]
– The frequency in Hertz of the lower tone component for a dual
frequency tone, or the frequency of the tone for a single tone. This parameter is
relevant only in case the tone is not Amplitude Modulated.

High Freq [Hz]
– The frequency in Hertz of the higher tone component for of a
dual frequency tone, or zero (0) for a single tone. This parameter is relevant only
in case the tone is not modulated.

Low Freq Level [-dBm]
– The generation level 0 dBm to -31 dBm. This
parameter is relevant only when the tone is not Amplitude Modulated.

High Freq Level [-dBm]
– The generation level. 0 to -31 dBm. The value is zero
(0) for a single tone. This parameter is relevant only when the tone is not
Amplitude Modulated.

First Signal On Time [10 msec]
– The “Signal On” period (in 10 msec units) for
the first cadence ON-OFF cycle, for cadence tone. When a tone is configured to
be continuous, this parameter defines the tone On event detection time. When a
tone is configured to be burst tone, it defines the tone’s duration.

First Signal Off Time [10 msec]
– The “Signal Off” period (in 10 msec units) for
the first cadence ON-OFF cycle, for cadence tone. In case of burst tone, this
parameter defines the off time required after burst tone ended until the tone
detection is reported. For a continuous tone, this parameter is ignored.

Second Signal On Time [10 msec]
– The “Signal On” period (in 10 msec units)
for the second cadence ON-OFF cycle. This may be omitted if there is no second
cadence.

Second Signal Off Time [10 msec]
– The “Signal Off” period (in 10 msec units)
for the second cadence ON-OFF cycle. This may be omitted if there is no second
cadence.

Third Signal On Time [10 msec]
– The “Signal On” period (in 10 msec units) for
the third cadence ON-OFF cycle. This may be omitted if there is no third
cadence.

Third Signal Off Time [10 msec]
– The “Signal Off” period (in 10 msec units) for
the third cadence ON-OFF cycle. This may be omitted if there is no third
cadence.

Fourth Signal On Time [10 msec]
– The “Signal On” period (in 10 msec units)
for the fourth cadence ON-OFF cycle. This may be omitted if there is no fourth
cadence.

Fourth Signal Off Time [10 msec]
– The “Signal Off” period (in 10 msec units)
for the fourth cadence ON-OFF cycle. This may be omitted if there is no fourth
cadence.