AudioCodes Mediant 8000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 203 / 924

Version 6.6 203 October 2014
Installation & Operation Manual 26. Connecting the Media Gateway to the IP Network
26.5 Additional Network Settings
This section describes additional network settings.
26.5.1 Static Routes
Static routes may be used to configure IP routing with entities or network segments to
which the Mediant 8000 communicates on a regular basis. Starting from v6.2, default
gateways may be configured for each IP subnet, which significantly reduces the need
for configuring static routes. Nevertheless, the configuration is still supported for
complicated network setups.
Static routes are configured separately for SC and TP boards – as described below.
The configuration may be applied instantly – without any adverse effect on the Media
Gateway service, by unlocking the corresponding configuration objects.
Note:
When the Mediant 8000 wishes to send an IP packet, it scans the static routes
table starting from the lowest index; the first entry that matches the IP packet's
destination IP address is chosen. Therefore, the order of the entries in the static
routes table is very important.
26.5.1.1 Static Routes for SC Boards
Static routes for SC boards are applied simultaneously to both Active and Standby SC
boards

To configure Static Routes for SC Boards:
1.
Click to access the Media Gateway status screen.
2.
In the Navigation pane, select
Networking SC Static Routes
; the SC Static
Routes list is displayed.
3.
Use the or buttons to add or remove entries.
4.
Select a specific row and then in the configuration pane, click
SC Static Route
Settings
; the Static Route Settings screen is displayed.
5.
Configure SC Static Route parameters according to the table below.
6.
Click the Maintenance icon and select
Unlock
to activate the configuration.