5/31
internal temperature measurement (Probe 2). It needs to be plugged to the bottom
sensor jack at the back of the controller. The tips of the probes are dropped into the
damper hole. Place a piece of tape on the top of the smoker tower to hold them in
place. The tip of Probe 1 should be placed close to the food but high enough so that it
does not touch the food. (See Figure 3). The tip of Probe 2 is to be inserted into the
meat.
Figure 3. Sensor position. Left, the sensor should be placed close to the food but high enough so that it
does not touch the food. Right, hold the sensor in place by a piece of tape.
For the “Original” and Stainless Steel Bradley smoker, the Temperature Heat Control
Switch on the smoker tower should be set to the Hi position (most right).
There are several ways to connect the controller and Bradley Smoker.
Smoke
Generator
Smoker
Tower
C
ab
le
B
Cable A
Figure 3.1 Power Cable wiring for Original Bradley Smoker
Cable A: Power cable for Smoker Tower, C14 plug
Cable B: Power cable for smoke generator, NEMA5-15P plug
