Auber Instruments WSD-1500H-W, Руководство по эксплуатации и инструкция

Страница: 16 / 32

16/31
00000000000000000000
00000000000000000000 >Step 1 SmkrTemp 250
1- End i ng by Fd Temp
00000000000000000000
00000000000000000000 > Back
Step 1 SmkrTemp 250
00000000000000000000
00000000000000000000 Smkr 137 Food 122
Set 250 Probe3 670
Step 1 SmkrTemp 250 Step 1 SmkrTemp 120
SE T
SE T
/
SE T
00000000000000000000
00000000000000000000
>Prog S tatus Stop
Step 1 SmkrTemp 250
Prog S tatus Stop
Prog S tatus Start
SE T
/
SE T
Figure 18A. Flow chart of how to use Program Status & Control function.
4.1.4 Switch between single-step mode and multi-step mode
To switch between single-step mode and multi-step mode, go to Parameter Setting mode
by holding the SET key, and then go to “
System Config ” menu, find parameter “ Program
Mode ”, then change it to “ ON ” (for multi-step mode) or “ OFF ” (for single-step mode). By
default, the controller is set to multi-step mode “ ON ”. Please see the flow chart in Figure
20 for how to access this parameter from the controller.
00000000000000000000
00000000000000000000 > System Con f i g
Back
00000000000000000000
00000000000000000000 >Program Mode ON
Output Hi L im i t 100
Program Mode ON
Program Mode OFF
SE T
SE T
/
SE T
00000000000000000000
00000000000000000000 >Back
Program Mode ON
SET
Multi-step Mode Single-step Mode
00000000000000000000
00000000000000000000 Smkr 137 Food 122
Set 250 Probe3 270
SE T
Press & Hold
Figure 20. How to switch between programmable mode and single-step mode
5. Controller parameter setup.
To access the parameters, press and hold SET key for about 2 seconds. Parameters are
divided into two groups: “
Control Config ” and “ System Config ”.