13/31
the “
X-Ending
” are set to time, the controller can operate with only the cabinet probe
(Probe 1) plugged in.
Note: user can also use Aubersmart app to view and change both time and food
temperature of each step.
Cooking Profile Example
Table 1. example program
Step
Number
Cabinet Temp.
(SmkrTemp)
X-Ending
(Ending)
Time/
Fd Temp
1
120
Time
2:00
2
190
Fd Temp
160
3
130
Time
20:00
4
0
Time
0:0
5
0
Time
0:0
6
0
Time
0:0
The example program for the controller is listed in Table 1. This program will control the
temperature of the cabinet at 120°F for 2 hours. Then, change the temperature to
190°F. It will stay at 190°F until internal temperature of the meat reaches 160°F. Then,
the controller will drop the temperature to 130°F for 20 hours, waiting you to pick the
food. If you change set temperature in step 3 (Step 3 SmkrTemp) to 0 and time for step
3 to 0, when food internal temperature reaches 160°F, the controller will shut off the
heater and stop the program. it will give beeping sound until the buzzer is muted or the
power input has been reset.
A flow chart of how to enter the cooking profile is shown in Figure 18. To start program
the cooking profile, press SET key shortly to enter the Cooking Profile Programming mode.
The top line in the display shows the step number “Step: 1” and the current target of
cabinet temperature “SmkrTemp 250”. To enter or edit the profile:
1) Use
▲
or
▼
key to move the cursor “>” to the parameter you want to edit.
2) Press SET key, the value to be edited should start blinking.
3) Use
▲
or
▼
arrow key to edit the value.
4) Then press SET key again to save the change. That parameter will stop blinking.
5) Use
▲
or
▼
key to go another parameter, repeat the previous operations till you
have finished entering all the cooking steps.
Note: New setting will NOT be saved if SET key is not pressed. After programming the
necessary steps for cooking, you can finish programming by pressing the Time/Back key
