ATX VersAtive Pro, Руководство по эксплуатации

Страница: 28 / 58

CHAPTER 4: TRANSCODING APPLICATION
4-2 VersAtive
®
Pro Enhanced – Operation Manual
4.2.2 Create an Ethernet Resource
1. Click on the Device icon to select it, Figure 4-2.
2. Click Add Eth Resource on the tool bar (or Right Click menu).
3. Choose the Ethernet port that the stream appears on from the Interface choices, eth0, thru eth5. (Depending on the
model ordered, may be more or less ports), Figure 4-3. There may also be virtual sources (VLAN) if any were created.
4. Enter the IP address , Port and choose the Protocol of the IP stream to be ingested.
5. Tick the Multicast box if this is a multicast stream with an address in the multicast range.
6. If the Stream is a Source Specific Multicast (SSM), enter the SSM IP Address.
7. If the stream is actually not present but you know it will be later, enter the Program Name , Program Number , select
Start On Signal then click Save Offline to save the settings (The stream will start when the signal is detected).
8. Click Analyze (only for streams that exist currently on a physical or virtual input; not required for Save Offline ).
NOTE: The Save Offline feature makes is possible to set up streams that are not yet present on
the input ports but you know they will be eventually. This allows the user to make resources for an
upcoming system that hasn’t been established yet. Without the offline resource feature you can’t
add any Ethernet resource if the VersAtivePro can’t find any program or service on a given IP.
NOTE: The Start on Signal check box is used when the resources are not currently available. If
and when the external IPTV network is built, the preprogrammed resources will start as soon the
signal is found.
1
2
Figure 4-2: Add New Ethernet Resource
3
4
5
6
7 8
Figure 4-3: Fill Resource Form