ATTO Technology FibreBridge 2390C, Инструкция по установке и эксплуатации

Страница: 42 / 51

xi
ATTO Technology Inc. FibreBridge Installation and Operation Manual
MinOpTemp (FB2390, FB2400 only)
Regulates/displays the minimum enclosure temperature
alarm of the FibreBridge in degrees Celsius.Valid entries
are between 0 degrees and 15 degrees
Default: 0
set MinOpTemp [0-15]
Requires a SaveConfiguration Restart command
get MinOpTemp
OpTempWarn (FB2390, FB2400 only)
Regulates/displays the number of degrees in Celsius
before a warning is sent to the user. Valid entries are
between 0 degrees and 15 degrees
Default: 5
set OpTempWarn [0-15]
Requires a SaveConfiguration Restart command
get OpTempWarn
Password
Specifies password for all non-serial sessions: Telnet,
FTP and ExpressNAV interface. You are prompted for the
current password, to enter the new password, and to
confirm the new password. If local Echo is enabled,
password echoes all * characters. If
VerboseMode has
been enabled, CLI requests that you re-enter the
password. When the password is all 0s, Telnet and FTP do
not validate the password and MD5 authentication is
disabled.Configure an empty password by pressing the
Enter key when prompted for the new password and the
new password confirmation.Passwords are case sensitive
and can be 1-32 characters long with no spaces.
Default: Password
set Password
Requires a SaveConfiguration command
Performance
Returns the performance data for the FC port you specify.
Data includes the average rate (MB per sec.) and number
of I/Os measured over the previous sampling period
where a sampling period is approximately one second.
Successful SCSI Read (08h, 28h) and Write (0ah, 2Ah)
commands are considered I/Os.Reported performance
may be affected by FC port and SCSI bus availability and
saturation, SCSI device speeds and overall system use.
get Performance <fp>
Ping
Sends an ICMP echo request to the specified host.
Ping [mp1] [xxx.xxx.xxx.xxx] <count <size>>
ReadOnlyPassword
Specifies password for all non-serial sessions: Telnet,
FTP and ExpressNAV interface. ReadOnlyPassword is
case sensitive, 0 to 32 characters, and cannot contain
spaces. Configure an empty password by not specifying
one.
Default: Password
set ReadOnlyPassword
Requires a SaveConfiguration command
ReadOnlyUsername
Specifies user name for all Telnet, FTP and ExpressNAV
user management console sessions.
Username is case
insensitive, 1-32 characters, no spaces.
Default: User
set ReadOnlyUsername
Requires a SaveConfiguration command
get ReadOnlyUsername
Reserve
Prevents other CLI sessions from modifying the
FibreBridge. When the FibreBridge services interface is
reserved, set commands are unavailable but get
commands are available. At least one service interface
always has access to the FibreBridge at all times. This
interface always reports
RELEASED status, since it
may issue set commands. Reservation of the FibreBridge
is implicit: if the configuration is changed by any user of
CLI sessions, the FibreBridge becomes
RESERVED .
Executing a SaveConfiguration command,
RestoreConfiguration or FirmwareRestart forced
releases the FibreBridge so that other devices may modify
it.
Reserve
Reset FCPortErrors
Resets all FC error counts for the specified port to zero.
Refer to
FCPortErrors .
command: ResetFCPortErrors [fp | all]
RestoreConfiguration
Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option undoes any changes made since the last
save.
RestoreConfiguration [Default | Saved]