ix
ATTO Technology Inc. FibreBridge Installation and Operation Manual
FCHard
Regulates FC hard address assignment. Under soft
addressing, the FibreBridge loop address is assigned
during loop initialization. Use
FCHardAddress
if you
enable hard addressing.
Default: disabled
set FCHard [enabled | disabled]
Requires a SaveConfiguration Restart command
get FCHard
FCHardAddress
Specifies the value used as the FC-AL hard
address. This value represents the address that
is used if hard addressing is enabled (refer to
FCHard
). The range of valid FC hard address
values are 0 through 125. The
all
option is only
available with the
get
command.
Default
fp1=3; fp2=4
set FCHard Address [fp | [address]]
Requires a SaveConfiguration Restart command
get FCHardAddress [fp | all]
FCMultiNode (FB2400 only)
Determines the reported identity of Fibre Channel ports.
When enabled, each port reports a separate unique Node
Name and logical units may be mapped to either port.
When disabled, each port reports the same Node Name
and each logical unit mapping is applied to all ports,
providing host-side failover and load balancing
capabilities.
Note
Changing this parameter causes all maps to
be deleted. Add new maps using the
AutoMap
or
Route
commands.
Default: enabled
set FCMultiNode [enabled|disabled]
Requires a SaveConfiguration restart command
get FCMultiNode
FCPortErrors
Displays the number of Fibre Channel errors that have
occurred since the last reboot/power-on or
Reset
FCPortErrors
command at the Fibre Channel
controller level.
Errors tracked:
Link Failure: Number of times link has failed due to
loss of signal, loss of synchronization for greater than
100ms, link fault, LIPs not being recognized for 45
ms or more in the normal-initialize state, or bad
N_port state transition
Sync Loss: Number of times signal synchronization
has been lost when the controller was not in the
offline state
Signal Loss: Number of times the FC controller has
detected a loss of signal
Invalid Tx: Number of times FC controller has
detected an
Invalid Transmission Word
during frame reception
Invalid CRC: Number of times the FC controller has
detected a frame received with a bad CRC
get FCPortErrors [fp | all]
FCPortList
Returns a list of available FC ports and their current
status. Valid status values are
Up, Down, Failed,
Reserved
and
Disabled.
FCPortList
FCSCSIBusyStatus
Specifies the SCSI status value returned when the
FibreBridge is unable to accept a SCSI command
because of a temporary lack of resources. Choices are
busy
and
queue full
.
Default: busy
set FCSCSIBusyStatus [busy | qfull]
Requires a SaveConfiguration command
get FCSCSIBusyStatus
FCSpeedLED2G (FB2370E)
Configures the FC speed LED. When enabled, the LED
lights for FC speeds of 2 Gb/sec. or 4 GB/sec. and turns
off for an FC speed of 1GB/sec. When disabled, the LED
lights for an FC speed of 4 Gb/sec.and turns off for FC
speeds of 1 Gb/sec. or 2Gb/sec.
Default: disabled
set FCSpeedLED2G [enabled | disabled]
get FCSpeedLED2G
FCWWName
Reports the Word Wide Name (WWN) of the FC interface.
Each FC port has an individual and unique WWN.
get FCWWN [PortNumber]
Содержание FibreBridge 2390C
Страница 5: ...Appendix D Warranty information xix Manufacturer limited warranty...
Страница 51: ...xx...
