ATTO Technology FibreBridge 2390C, Инструкция по установке и эксплуатации

Страница: 11 / 51

6
Manual reset switch
A manual reset switch reboots the FibreBridge.
To reset the FibreBridge, depress the reset button
for no more than three seconds.
To restore factory defaults, press the reset button
for more than four seconds until the green
Ready
LED blinks.
LED indicators
The LED indicators can be viewed from the connector
(back) side and the front side of the FibreBridge
2390R/D. (See Exhibit 1.2-1)
LEDs on the connector (back) side are:
A bicolor Ready/Fault LED
lights green to indicate
ready, lights yellow to show a faulted condition, and is
off to indicate not ready.
Embedded in the Ethernet port connector:
a
lighted green LED shows a valid link; off indicates
that no link is present. A separate blinking yellow LED
indicates activity.
Fibre Channel port:
A lighted green LED indicates
link; off means no link. A separate green LED
indicates activity if it is lit, no activity if it is off.
SCSI ports:
A green LED on each port indicates
activity if is lit.
LEDs on the front panel are:
A bicolor Ready/Fault LED
is lighted green to
indicate ready, lighted yellow to show a faulted
condition, and off indicates not ready.
SCSI ports:
A green LED on each port indicates
activity if is lit.
Fibre Channel port:
bicolor LED indicates FC
speed. If it is off, speed is 1-Gb; if it is green, 2-Gb,
and yellow indicates 4-Gb FC. A separate green LED
indicates activity if it is lit, no activity if it is off.
Exhibit 1.2-1 Fibre Bridge 2390R/D dimensions with front panel LEDs and connector side details
S erial port
R eady, Fault LE D s
Ethernet port Fibre C hannel port
FC A ctivity, Link LE D s
S C SI ports Pow er receptacle
SC S I A ctivity LED s
R eset sw itch