ATTO Technology FibreBridge 2390C, Инструкция по установке и эксплуатации

Страница: 38 / 51

vii
ATTO Technology Inc. FibreBridge Installation and Operation Manual
DisplayEventLog
Displays the event log. The event log may be filtered using
the
DisplayEventLogFilter command. The optional
parameter n is the number of lines to be displayed as
a
single page with no user interaction. After the
command has executed, use
+ , - or = to scroll
through the log . Type quit and press Enter to exit the
command.
DisplayEventLog <n>
DisplayEventLogFilter
Filters the display of data for specified subsystems and
levels if
DisplayEventLog is enabled. Valid event log
subsystem entries are platform-dependent. For set
commands, the final parameter indicates whether or not
events from the specified subsystem and level are
displayed.
Default: all all all
set DisplayEventLogFilter [subsystem | all] [level | all] [all
| none]
get DisplayEventLogFilter [subsystem | all] [level | all]
DisplayTraceLog
Displays the most recent page of trace log entries. The
optional parameter
n is the number of lines to be
displayed as
a single page with no user
interaction. After the command has executed,
use
+ , - or = to scroll through the log . Type quit and
press Enter to exit the command.
DisplayTraceLog <n>
Fibre Channel trace log entries depict
FC: an FC trace log
PortID the hexadecimal loop ID of the host device
Bus: specifies the hexadecimal SCSI bus number
Target ID: specifies the hexadecimal SCSI target
device number
CDB: each Cx character represents the hexadecimal
byte-wise contents of the command’s SCSI
Command Descriptor Block. SCSI CDBs with less
than 16 bytes are padded with zeros
SCSI trace log entries depict
SCSI: a SCSI trace log
Bus: hexadecimal SCSI bus number
Target ID: hexadecimal SCSI target device number
LUN: hexadecimal SCSI logical unit number
CDB: each
Cx character represents the hexadecimal
byte-wise contents of the command’s SCSI
Command Descriptor Block. SCSI CDBs with less
than 16 bytes are padded with zeros
Stat: hexadecimal byte-wise SCSI status return code.
Sense Data: each
Sx character represents the
hexadecimal byte-wise contents of the sense data
returned by a target device in response to an
attempted SCSI command. Maximum 18 bytes of
sense data is all zeros for commands that did not
cause the target device to return sense data.
DisplayTraceLogFilter
Filters the display of data for specific ports if
DisplayTraceLog is enabled.
set DisplayTraceLogFilter [FC | SCSI | all] [fp | sb | all]
[none | chkcond | all]
get DisplayTraceLogFilter [FC | SCSI | all] [fp | sb | all]
DumpConfiguration
Displays the FibreBridge configuration.
DumpConfiguration
DumpEventLog
Dumps the entire contents of the event log to the
ExpressNAV Advanced page text box, RS-232 or Telnet
session.
DumpEventLog
DumpTraceLog
Dumps the entire contents of the trace log to the
ExpressNAV Advanced page text box, RS-232 or Telnet
session.
DumpTraceLog
EmailFromAddress
Configures the Email address that the FibreBridge uses
to communicate with the Email server. Full Email
address is a fully qualified Internet Email address, not
more than 128 characters long.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify
Regulates Email notification.
Default: disabled.
set EmailNotify [enabled | disabled]
get EmailNotify