AT-OMNI-111 / AT-OMNI-112
42
The AMS Interface
Source
Select the desired HDMI input from the
Source
drop-down list.
Enabled (Audio)
Click the
Enabled
check box to enable the audio stream. To disable the audio stream, do not check this box.
By default, audio streaming is
disabled
.
Destination IP Address
Enter the endpoint IP address in the
Destination IP Address
field.
Destination UDP Port
Enter the UDP port in the
Destination UDP Port
field.
TTL
Set the
Time-To-Live (TTL) duration, from 1 to 255 seconds, in this field. The default value is 255 seconds.
DSCP
Select the Differentiated Services Code Point (DSCP) type from the
DSCP
drop-down list. This value will be used to
determine the Quality of Service (QoS) on a network. The available values are: Best Effort, Low, Normal, High, and
Highest. The Best Effort setting will provide normal priority for data packets, while a setting of Highest will prioritize
data packets as critical. However, it should be noted that a higher priority setting may also result in high data packet
loss, depending upon network traffic.
FEC rows
Specify the number of FEC rows in this field. Refer to
for more information.
FEC Columns
Specifiy the number of FEC columns in this field. Refer to
for more information.
FEC rows
and
FEC Columns
only applies when FEC is
enabled
.
When enabled, the number of
rows
and
columns
will be used for each data packet, causing an FEC packet to be added to each row and column, providing burst error
correction. For example, a five-row, five-column FEC structure would add a five-row and five-column FEC packet to
every 25 data packets. This allows error correction of up to five packets in length, in addition to replacing missing
data packets. Refer to
for more information.
