10
u
nit
P
laCement
• The
Sanidyne
®
Prime Remote
is intended for indoor use only. The
Sanidyne
®
Prime Remote
should be protected from
liquid intrusion such as dripping water, condensation or mist, and used only in a clean, dry location with temperature ranges
between 40°F and 95°F.
•
Electrical power supplied to the
Sanidyne
®
Prime Remote
unit must match power requirements listed on the
Sanidyne
®
Prime Remote
.
•
The
Sanidyne
®
Prime Remote
is intended for use in UNOCCUPIED AREAS ONLY. Under no
circumstances should this sanitizer be permitted to operate with humans, plants, or animals present in the Operation Area
.
•
The intrusion sensors will detect movement if anyone is in the treatment area and the lamps will be switched off until unit is
reset by pressing the
START/STOP
button on keypad on the top of the unit.
•
For maximum efficiency the
Sanidyne
®
Prime Remote
should be located as centrally as possible, away from the corners of
the treatment area. The
Sanidyne
®
Prime Remote
Portable Area Sanitizer is most effective when it is located in the center
of the room and the ultraviolet rays are unobstructed.
UNIT OPERATION
P
re
-o
Peration
1.
Fully charge the Hand-held Remote Controller (Shown in
Figure 3
).
NOTE:
Charger provided operates on 100 volts to 240
volts 50/60Hz and has a NEMA 1-15 plug.
2. Once a location has been chosen for the
Sanidyne
®
Prime Remote
, post supplied
Promate
™
Danger Signs
on all access
doors to the area where treatment operation will take place.
It is the user’s responsibility to post signs, or notices for all personnel and persons in the building or
facility so that they be made aware that the Operation Area is off limits during treatment.
3.
Connect the
Sanidyne
®
Prime Remote
to a properly grounded outlet power source which matches the power
requirements listed on the
Sanidyne
®
Prime Remote
(See Power In location shown on
Figure 1
– View A-A).
An approved
Promate
™
Face Shield (1) is supplied with each unit.
Promate
™
Face Shield MUST be
worn prior to the next step by the operator as well as anyone else in the operation area. In addition the
operator and anyone present MUST
use protective gloves and clothing to protect skin from UV rays.
4.
Turn power on using the Power Switch located on the rear of the
Sanidyne
®
Prime Remote
(See Power Switch location
shown on
Figure 1
– View A-A). Switch will glow
RED
when power is on. Once unit receives power, the
RED
lights located
just below the Occupancy Sensors on the top of the unit will glow
RED
. (See Occupancy Sensors (4 Total), shown on
Figure 1
– Dimensional Data). This is not a warning, it indicates that the sensors are aware of your presence.
Step 3:
Once pins are aligned
correctly, press lamp base into lamp
socket until it is properly seated.
Step 4:
Applying pressure
with your thumb on outside of
Sanidyne
®
Prime Remote
, snap
lamp base into the appropriate clip
directly above its lampholder.
Step 5:
Install the remaining seven
lamps as described in steps 1–4.