9
Wednesday
11:00
21
.5°C
Wed. 11:00
Set point:
COMFORT
Wed. 11:00h
21
.5°C
Set point:
COMFORT
21
.0°C
OK
Set point:
OK
ECO
18
.0°C
Set point:
OK
ANTI-FROST
7
.0°C
Set point:
21
.5°C
Wed. 11:00
Set point:
COMFORT
OK
CONFIG
COMFORT
ECO
ANTI-FROST
PROGRAM
SETTINGS
COMFORT
OK
CONFIG
COMFORT
ECO
ANTI-FROST
PROGRAM
SETTINGS
COMFORT
TIME
Settings
DISPLAY
Settings
ADVANCED
Settings
OK
SETTINGS
TIME
DATE
DST
TIME SETTINGS
OK
To amend the temperature set points used in
the program mode, press and hold the CONFIG
button until the following screen appears:
Select either Comfort, Eco or Anti-Frost and
press OK to enter the menu.
Press the +/- button to change the temperature
of each mode then press OK to confirm and return
to the main operation screen, repeat the above to
set the other program temperature set-points.
MANUAL PROGRAMMING
SETTING THE TIME AND DATE
To assist with programming the TFT screen is
backlit and will stay illuminated for approximately
10 seconds after the last button is pressed. (To
change the backlight time, see the section on
DISPLAY)
When the convector is operational and the room
temperature is lower than the set temperature the
heating symbol will be shown indicating that
the convector is producing heat. When the room
temperature equals or is above the set temperature
the heating symbol will not be present indicating
the convector is not producing heat.
The following screens show
OFF
,
AUTO
and
MANUAL
modes. To change between the different
modes press
OK/Mode
button.
When the convector is in
AUTO
mode the
temperature can be adjusted by pressing the +/-
buttons. This change will remain active until either
the next programme change or until midnight when
the temperature will revert to the preset value.
When the temperature has been adjusted in
AUTO mode a hand will show beside the auto to
symbol to show the amended set-point.
To manually return the heater to the set-point,
cycle the modes until returning to AUTO.
Use the +/- keys to set the temperature when
the convector is in
MANUAL
mode.
NOTE: To rapidly change the temperature set-
point in any mode press and hold the +/- keys.
SET PROGRAM TEMPERATURES
If a convector is paired with a Gateway then
the local time from the internet is automatically
applied to the convector.
To set the Clock on an unpaired Convector, press
and hold the CONFIG button until the CONFIG
menu is shown and then select SETTINGS, press
OK and then select TIME Settings and press OK
again .
In the TIME menu the Time, Date and Daylight
Savings (DST) can be set.
