14
Runback Config
Setback
Max. Temp.
OK
Runback
Runback Config.
OFF
ON
Settings
OK
Runback
Status ON
Change
Password
OK
Status
ON
OFF
Password
OK
Status ON
Change
Password
OK
CONFIRM
NEW PASSWORD
1 2 3 4 OK
ENTER NEW
PASSWORD
0 0 0 0 OK
PASSWORD
The Password Function of the Merida convector
serves a number of functions; Keylock, Advanced
menu access and also Runback access when the
Runback is activated. The Default password from
the factory is four zero’s (0 0 0 0), however it is
strongly recommended
that once installation is
complete that an alternative code is set.
To access the password function enter the
ADVANCED SETTINGS menu (see above) and
then select PASSWORD.
The password can be turned on or off and
changed.
To Turn the password on or off, Select Status
and press OK.
Select either “ON” or “OFF” and press OK.
If you are reactivating the password then the
Enter New password screen is shown (The
password will always default back to 0 0 0 0).
If the password is turned off, the Keylock,
Advanced Settings menu and Runback controls
are accessible without entering a password.
To Change the password code when the
password is active select Change from the
password screen and press OK.
Enter and confirm the new password and press
OK.
RUNBACK MODE
The Merida convector comes with a Runback
mode for use when the heater will be installed in
areas where
restricted
user control is required.
When Runback Mode is active it allows the user
to set the convector to run for a specific pre-set
amount of time and temperature. It is also possible
to set a maximum temperature (Max Temp) above
the Runback setting to allow the user to increase
the temperature within the limits allowed.
Before activating Runback mode it is strongly
recommended that an alternative password is set
and activated and the comfort mode temperature
set-point is set to 35°C. When the password is
activated the user will have no access to any
convector settings without the password.
NOTE: Any Display settings will be used in
RUNBACK mode, eg. Backlight time and intensity,
Eco mode etc. These should be adjusted prior to
setting Runback to Active.
After the Runback time period ends the room
temperature will return to off (7°C minimum) until
the Runback is restarted.
It is also possible to set a minimum temperature
to be maintained (Setback) outside of the
Runback mode; when setback mode is activated
the room temperature will only fall as low as the
Setback temp and be maintained at this point until
Runback is restarted.
ACTIVATING RUNBACK MODE
Runback mode is activated
from the Advanced settings
menu.
The main Runback screen
has 3 options:
•
Runback Config
•
Setback Config
•
Max Temp
Set Runback to ON to
activate the mode.
Note:
The
Runback
settings menu is not available
unless the Runback mode
has been turned on.
