8
Wed. 11:00h
21
.5°C
Set point:
Wednesday
11:00
21
.5°C
Wed. 11:00
Set point:
COMFORT
Wed. 11:00h
21
.5°C
Set point:
main
switch
error messages
err03
EASY MODE
EASY
Low Surface
Temperature
MODE
LST 75%
open window
self adaptive
AWAY status for
geofencing
MERIDA
BOOST
CONFIG
MODE
TIME
OPERATING INSTRUCTIONS
The control is based on four buttons and a TFT display.
Switching ON (Master):
Once the convector has been mounted on the wall
and correctly connected to the mains electricity power
supply, press the main On/Off switch on the right hand
side of the convector.
After around 3 seconds the screen will show various
information and the convector is ready to operate. It is
recommended to leave the convector on and use the
standby function (below) to turn the convector off when
it is not required.
Switching OFF (Master):
To switch off the convector press the main On/Off
switch on the right hand side of the convector. The TFT
screen will turn blank and the convector will lose any
connection with the Gateway.
Stand-by function:
From any “On” screen press the OK/Mode button until
the
symbol is present as shown in the following
screen.
When the convector is in Stand-by Mode it will retain
programs and continue to communicate with the
Gateway (if connected) but will not heat.
To switch the convector on again, press the MODE
button to choose programme mode (
) or manual
mode (
) you will see the following screens:
In any of the operation modes the area above the
temperature set point may display a message showing
the status of the convector, see the following screens:
Decrease
Increase
Mode/OK
AUTO / MANUAL /OFF
BOOST/
CONFIG
(long press)
Current time
Current mode if
AUTO is selected
Set point temperature
Day of the week
Heating indicator
Radio paired icon
Current Mode
(AUTO, MANUAL, OFF)
Merida Convector Controls
Notification area
The first press of any button will wake up the convector any
further button presses will activate the function required.
Note: The 4 symbols on the side of the screen
will change depending on the menu that the
user is accessing.
