33
Appendix
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the
box. These instructions are intended for California Energy Commission (CEC) compliance
testing only. When the CEC battery charging testing mode is activated, all telephone
functions, except handset battery charging, will be disabled.
When first purchased and properly installed for charging (see the
Battery installation
and charging
section on pages 6-8), put the cordless handset in the handset charger to
charge. The CEC battery charging testing mode is activated while charging.
If you have registered the cordless handset to the
TL96276/TL96456
base, below are
the testing instructions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are plugged with charged batteries before proceeding.
2. While you press and hold
/HANDSET LOCATOR
, plug the telephone base power
adapter back to the power outlet.
3. After about 20 seconds, when the
HOME
light starts flashing, release
/HANDSET LOCATOR
and then press it again within two seconds. You hear a
confirmation tone. The
HOME
light turns off and all handsets display
To register,
see user manual
. Allow up to one minute for the process to complete.
If the phone fails to enter this mode, repeat Step 1 through Step 3.
The telephone base will be powered up as normal if you fail to press
/HANDSET LOCATOR
within two seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 9-10 for handset
registration instructions.
BC
