10
Registration and deregistration
Add and register handsets
If registration fails, the system will automatically try to register
again. If registration fails after the third try,
Registration failed
appears on both screens. The handset shows
To register, see user
manual
and the telephone base returns to idle mode. This may
take up to five minutes to occur. Please start again from Step 1.
Method 2:
Press and hold
/HANDSET LOCATOR
on the telephone base
for about four seconds and it shows
Registering... Please wait
.
Release
/HANDSET LOCATOR
.
Press
QUIET #
on the handset. The handset shows
Registering... Please wait
. If the registration is successful, both
the handset and the telephone base screens display
HANDSET
X Registered
(
HANDSET
represents the handset name,
X
represents the handset number). Both the handset and the
telephone base beep. The handset is now registered with the
telephone base.
If registration fails,
Registration failed
appears on both screens. The
handset shows
To register, see user manual
and the telephone
base returns to idle mode. This may take up to five minutes to
occur. Please start again from Step 1.
NOTES:
You cannot register a handset if any other system handset is in use.
If you try to register more than 12 handsets to the telephone base, the
telephone base shows
Registration slots are full
and sounds two beeps.
1.
2.
•
•
If it is the first time you install your AT&T
TL96276/TL96456
telephone system, or power
returns following a power outage, the handset
will prompt you to set the date and time when
registration is successful. After that, it will prompt
if you want to set up the answering system via
voice guide. Press
YES
on the handset to start.
For details, see the corresponding sections in the
telephone system’s user’s manual. To skip these
settings, press
OFF
/CANCEL
on the handset.
SET DATE
09/30/16
MM/DD/YY
BACK NEXT
Start voice
guide to set
up Answering
system now?
NO
YES
