EN 22
Symptom
Possible cause
Solution
A fuse blows as soon as the
hob is switched on.
The hob has been wrongly
connected.
Check the electrical
connections.
Fault code F00.
The control panel is dirty or
has water lying on it.
Clean the control panel.
Fault code F0 ... F6 and FC.
Defective generator.
Contact the service
department.
Fault code F7.
The ambient temperature is
not good.
Switch off all heat sources
in the vicinity of the cooking
plate.
Fault code F8 and F08.
Appliance over heated.
The appliance has been
switched off because of over
heating. Let the appliance cool
down and start again on a
lower setting.
Fault code F9 and/or
continuous beep.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Let your connection be
changed.
Fault code F99.
You have pressed two or more
buttons at the same time.
Do not operate more than one
button at the same time.
Fault code FA.
Mains voltage is too low.
Contact your energy supplier.
Fault code FAN.
Air circulation not good.
Make sure the venting holes
under the cooking plate are
open.
Fault code E6
Wrong pan.
Suitable pans are available via
the website ‘www.atag.nl’.
Hardware / software error.
Contact the service
department.
Other fault codes.
Defective generator.
Contact the service
department.
FAULTS