Astria.us.com
900704-00E
22
11. Rest the middle crossover log onto the right
middle log and the left front log
(see
Figure 39
).
Make sure to match the projection on the bottom
of the crossover log with the recess area in the
right middle log and the left front log.
12. Place the top rear log onto the rear log as shown.
The rear log has a projection that will fi t into the
recess area on the bottom of the top rear log
(see
Figure 40
).
INSTALLATION
Continued
Figure 38 - Installing Left Top Log
Figure 39 - Installing Middle Crossover Log
Figure 40 - Installing Top Rear Log
Top Rear
Log
Rear Log
Rear Log
Left Top Log
Left
Middle
Log
Middle
Crossover
Log
10. Place the left top log onto the rear log and the left
middle log. Make sure to place the projection on
the bottom of the left top log into the recessed
areas on the rear and left middle logs
(see
Figure
38
).
EMBER PLACEMENT
WARNING: Do not use any other ember
material not supplied with this unit.
WARNING: Do not operate unit without
ember material correctly in place as shown
in
Figures 42 & 43, Page 23
. Do NOT place
ember material anywhere else on the
unit. Use only ember material supplied
with unit. Excessive or incorrectly placed
ember material may produce carbon
monoxide or soot.
If replacement embers are needed, the
replacement embers must be purchased
from IHP. See
Page 43
for part numbers.
1.
Ember Chunk Placement.
The Blaze&Glow24
burner systems include three ember chunks
that are designed to fi t over shoulder screws
on the ember pan burner. The bottom of each
ember chunk has a hole for securing the ember
chunk in place when it is placed over a shoulder
screw.
WARNING: ALL PREVIOUSLY AP-
PLIED LOOSE MATERIAL MUST BE RE-
MOVED PRIOR TO REAPPLICATION.
