TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
109
6
Click "Move".
Existing RFPI on the new Radio is replaced by the broken Radio’s RFPI. The new
Radio’s RFPI is now released and can be reused. All other RFPIs in use are not
affected. The broken Radio will be deleted from the Static Registrations section.
8.10.2 RFPs
This section only applies to the IPBL.
Information about the DECT devices connected to the IPBL. For explanation on the
information, see the table below.
1
Select Device Overview > RFPs.
2
Click the applicable port to open the RFP details pop-up window.
Figure 25. å
Figure 26.
Port
The port used in the IPBL.
Status
Current status of the IPBS connected to the IPBL.
Description
A short description to help identify the IPBS.
RFPI
Identity number.
SW Version
The current software version.
Hardware
The hardware version.
Boot
RFP boot version.
Connected Time
The elapsed time since the RFP connected to the IPBL.
Cable Delay
The delay caused by the cable.
Tx Error
The number of transmitting errors.
Rx Error
The number of receiving errors.
3
The following actions are available:
• Click "OK" to save your settings and close the pop-up window.
• Click "Cancel" to close the pop-up window.
• Click "Refresh" to update the information.
• Click "Reset" to reset the RFP.
8.10.3 Sync Ring
This section only applies to the IPBL.
A wire map of the synchronization ring is available in the GUI. The identities (IPBL-xx-xx-xx)
of the IPBLs and the position in the ring is displayed. If the ring is broken it is possible to
locate where. Click the IP address to access another IPBL.
1
Select DECT Sync > Sync Ring.
8.10.4 Sync Ports
This section only applies to the IPBL.
Displays the current status of the synchronization ports.
1
Select DECT Sync > Sync Ports.
Status
The current status of the port.
