Ascension VIRTUOSO 5460F, Руководство по эксплуатации продукта

Страница: 21 / 56

Product Manual SECTION 4
VIRTUOSO 5460F
115057 REV L
15
possible while moving it. A minimum of two (2) people is recommended for moving
the skirt.
To reinstall the lift car skirt , perform the following steps in the order indicated. If
necessary, refer to the figures in the skirt removal instructions above for identification of
skirt components.
1. Raise or lower the lift car so that the lift car floor is approximately 15" off the ground.
2. Move the skirt into position around the lift car, approximately as it will be located
when installed on the lift. Use extreme care to support the skirt in its natural position
as much as possible while moving it. A minimum of two (2) people is recommended
for moving the skirt.
3. At both front corners of the lift car, lift the skirt guide tubes upward, move the skirt
into place, and insert the guide tubes through the slots in the skirt. Then turn the
guide tubes clockwise onto the base studs, using pliers to tighten them.
4. In the back, reinstall the skirt guard onto the lift car by performing the following
steps. Refer to the figure at the top of the following page as necessary.
a. Position the skirt guard underneath the ball bearing slide rails on the lift car, so
that the slide rails on the skirt guard line up with the slide rails on the lift car.
b. Move the skirt guard upward, while making sure that the skirt guard tabs slide
behind the retaining flanges on the lift car, and that the slide rails on the skirt
guard lock into the slide rails on the lift car.
c. You will feel and hear a "click" when the ball bearing slide rails engage each
other, and the skirt guard will be held in place. If the skirt guard was installed
correctly, the guard cannot be pulled away from the lift car. If this is not the case,
use the release levers to release the skirt guard and then reinstall it, taking care
to slide the skirt guard tabs behind the retaining flanges on the lift car.
d. Reinstall the 5/16”-18 screws into the holes in the lift frame just above where the
ball bearing slides enter the frame.
CAUTION!
In the following step, stay clear of the lift car when it is moving to avoid any
pinching and/or crushing hazards.