Product Manual
SECTION 4
VIRTUOSO 5460F
115057 REV L
20
4.7 Lower Platform Gate Switch
The lower platform gate switch senses whether the lower platform gate is open or
closed. The switch is located on the lift car at the hinge side of the gate, about 12" [305
mm] from the lift car floor. Refer to the right-hand figure below. The switch has wires
connected to its normally open (NO) and common (COM) terminals.
The gate switch is in correct adjustment if the lift car will operate only when the gate is
closed. The gate is considered to be closed if the upper locking rod in the gate engages
in the lock cutout as the lift car moves off the ground. See the left-hand figure above for
the location of the lock cutout.
If the lift car can be raised off the ground with the gate open far enough for the locking
rod to fall outside of the lock cutout, then the switch probably needs to be recessed
further into the lift car wall. (In this case, the lift car will not go higher than 2" [50 mm] off
the ground.) If the lift car stops just after it begins to rise off the ground, then the switch
may need to be extended further out of the lift car wall.
Содержание VIRTUOSO 5460F
