Product Manual
SECTION 4
VIRTUOSO 5460F
115057 REV L
12
4.4 Retracting, Removing, and Reinstalling the Safety Skirt
The safety skirt consists of two parts: the lift car skirt, which guards the lift car on three
sides; and the gate skirt, which guards the area under the lower platform gate. For
some of the repairs described in this manual, it is necessary to gain access to
components normally hidden behind the skirt. In most cases, only a small portion of the
skirt may need to be retracted; however, sometimes it may be necessary to remove the
whole skirt.
To remove the
gate skirt
, perform all of the following steps. If the skirt only needs to be
retracted, performing only Step 3 will provide access to many of the components behind
the skirt. Refer to the figure below for the location of the fasteners referenced in each
step.
1.
Use a 5/16" wrench to remove the three (3) hex head screws that secure the skirt
to the skirt base. These screws are located on the top side of the skirt base.
2.
Using any operating station, raise the lift car until the car floor is approximately
24" [610 mm] off the ground.
Содержание VIRTUOSO 5460F
