Ascension VIRTUOSO 5460F, Руководство по эксплуатации продукта

Страница: 38 / 56

Product Manual SECTION 4
VIRTUOSO 5460F
115057 REV L
32
4.15 Skirt Guard
The skirt guard is located on the upper landing side of the lift car, below the gate. The
skirt guard blocks the upper platform gate from opening when the lift car is at the lower
landing, but slides out of the way as the lift car moves away from the lower landing.
To detach the skirt guard from the lift and safety skirt, perform the following steps:
1. Move the lift car to the upper landing.
2. From inside the lift car, remove the lower portion of the upper platform gate (secured
to the gate with five (5) pan head screws) and the bridge plate (secured to the skirt
guard with four (4) flat head screws).
3. Detach the protective skirt from the long sides of the lift car by removing the ten (10)
pan head screws on each side that secure the sides of the skirt to the lift car.
4. Use a 5/16" combination wrench to remove the two (2) hex head screws that secure
the top of the skirt to the lift car on the upper landing side, one (1) at each corner.
Remove the small skirt support brackets that are freed when these screws are
removed.
5. Remove the (2) 5/16”-18 screws from the lift frame just above the ball bearing slides.
6. Retract the skirt around the ball bearing slides as shown in the figure below. You
will need to hold each skirt panel approximately horizontal to move it past the
restraining tab.