Page 28 / 49
2.) The throttling is set to 0%
11.3
Start of the machine.
Insert the key in the emergency stop/main switch of the
machine. It is positioned in the right side of the machine.
Turn the key and the knob is pushed up. Now the
ignition light to the left of the emergency stop is lit.
Please note
: The motor cannot be started if the mower is
in service position.
The starting sequence is shown in the picture below:
After the machine has been started it is important to let the
motor run idle for minimum 2 min. This particularly
applies in very cold weather.
Important
: The motor must never run more than 5 sec.
from the self-starter because it will heat and can then be
damaged.
Before a new attempt to start the motor again, at least 10 sec. have to pass.
Warning
: Keep a distance to the machine when it is started.
Emergency stop/main
switch
Ignition lamp
1.)
Turn the emergency stop/main switch.
A small dot appears on the display.
The horn sounds a beep to signal that
sender and receiver of the remote
control are connected.
4.) Activate the starter button.
Release the button as soon
as the motor starts.
2.) The horn is
activated briefly
Display
3.) Activate the chock. After
start, deactivate the chocke
