ARTE NIREAS, Инструкция по установке и эксплуатации

Страница: 25 / 30

I
NSTALLATION
&
USER MANUAL
WATER HEATING FIREPLACE
| NIREAS
24 | Page
10.2.7. How to clean the inside parts of ARTE® NIREAS fireplace
During the annual visit of your local chimney sweep and during the cleaning of internal parts of the fireplace, it is recommended to remove
all internal parts of the combustion chamber to be also cleaned.
(
Κεφάλαιο
10.4)
10.3. Internal parts removal
To remove the metal baffle place the supplied handle into the hole of the baffle and push
to lift it (
1
). Then move it towards your side and with the other hand catch it from the outside
of the water heating beams. Continue pulling towards you and simultaneously push with
your other hand from behind (
2
) and when you meet the inner side of the fireplace, turn it
down (
3
) to release it and remove it from the main door (
4
).
10.4. Inactive fireplace for prolonged periods
IMPORTANT NOTICE:
If the fireplace is not used for some time, clean it thoroughly and let the
air control layout slightly open in order to let the air circulate. Ensure that the rainwater
cannot infiltrate from the flue. Place a chimney cap that does not completely block the
flue.
These actions should ensure there is a slight movement of air through the fireplace, and that
the body and combustion chamber remain dry, right into the corners.
Ash that remains in the fireplace, when not in use, can absorb moisture like blotting paper. If
moisture settles inside the fireplace, it forms rust which expands the more it settles. This can
cause excessive pressure on the fireplace joints, thus causing damage.
NOTE:
It is recommended to thoroughly clean the fireplace at the end of the operating season Adding desiccant in the combustion
chamber, such as cat litter, helps absorb moisture during the summer. Make sure to remove it before the beginning of the operating season.
11. T
IPS
& T
RICKS FOR
R
ESOLVING
I
SSUES
The wood does not ignite by lighting the fireplace. The fire just smokes. The fire burns out
Open the air supply
You are not using proper kindle
The wood is too wet
The logs are too thick
The ash is over the appropriate limit
Intense smoking in the combustion chamber, intense soot deposition on the glass
Open the air supply
Small quantity of wood
The wood is too wet
The logs are too thick
There is smoke coming out of the fireplace
Check if there is adequate draft into the flue, light a test fire
Make sure there is sufficient air supply
Removal of steel baffle
The qualified dealer in your area is available to
answer any of your further questions
We hope you enjoy many years of carefree warmth with
ARTE ® NIREAS fireplace. Some initial experimentation with
loading and operating techniques will help you decide your
normal routine. If you have any problems after this short
learning period, please contact your local ARTE® dealer. In
case, for any reason, they can’t help, please contact us in
writing at the address on the front of this manual.
Maintenance on the fireplace must be done ONLY when the device is cold.