Arrow 697.68608-A, Руководство пользователя и инструкции по сборке

Страница: 41 / 43

41
●
Parts Needed For
●
Horizontal Track Roll-Up-Door
Step 30
BW41
● ● ● ● ●
7913 Spring Support Bracket (2)
STEP
2
STEP
1
STEP
3
STEP
5
1
Install spring support brackets to
the roof beams using #10-32x7/16"
bolts and #10-32 square nuts.
2
Attach the right and left horizontal
track to right & left vertical track using
bolts and nuts shown, following
Wayne Dalton Instructions.
3
Fasten horizontal tracks loosely to
spring support brackets using 1/4-
20x1 1/2" hex head bolts and 1/4-20
square nuts. Tighten all bolts and
nuts.
CAUTION:
FROM THIS POINT ON, BE SURE
TO USE EXTREME CAUTION
UNTIL THE DOOR IS PROPERLY
SPRUNG AND OPERATING
4
Attach "S" hooks to both springs.
Fasten sheave and sheave fork to
opposite ends of springs following
Wayne Dalton Instructions. Attach
spring assemblies to spring support
brackets.
STEP
4
Roof Beam
7913
#10-32 Square Nut
1/4-20 Square Nut
Horizontal Track
1/4-20 x 1 1/2"
Hex Head Bolt
10-32x7/16" Bolt
3/8-16 x 1 1/4"
Hex Head Bolt
Spring "S" Hook
7913
Snubber Cable
3/8-16
Hex Nut
Steel Sheave
3 Hole Clip
Snubber Cable
7913
Flagangle
5
Thread cable with one 3
hole clip attached thru a hole
in the flagangle, then thru the
spring and spring support
bracket. Pull tight and attach
the 3 hole clip to the free end of
the cable.
Check
Be sure that the lift cables do not rub and/or the rollers do not bind
in the track when door is opened or closed. Recheck the springs
to be sure that there is equal tension on both springs. This is
extremely important for proper door operation.
Note
Reckeck all door fasteners
and hardware to be sure that
each fastener is tight and
secure.