Array electronic AF-10MR-A2, Руководство пользователя

Страница: 48 / 129

Chapter IV Programming on FAB2 panel
USER'S MANUAL
4.3.1.2 Rom→FAB2 Read/write/modify Program Interface
The user can view the function block number of the FAB2 program on this
interface, and can modify the parameters of the function block number.Such as
DPR,DDR and UCN and so on.
When the user enters the Rom → FAB2 program interface through FAB2/Rom
interface , select the function block number to be viewed or modified by the +/-
keys.The function block number in the AF-HMI panel starts from 0, and the B0
block number corresponds to the B1 block number in the QUICKII software.
1) Timing function block
Time unit:
Unit Unit(1-hour, 2-minute, 4-second)
Int. Integer bit
M Decimal places
As shown in Fig 4.8, B002 function block is MPLR single pulse function
block,The parameter is 30.3 seconds.If you want to modify the parameter, pls
kindly remove the cursor to the modified bit you need, then set up the parameter
via+/- keys.
Fig 4.8
2) Counting function clock
Counting unit:
Consisting of six digits, the highest position is the leftmost, the lowest position is
the rightmost, and his range is 1-999999
For example. As shown in Fig 4.9
B018 function block is COUNTU ,the parameter of Upward counting function
block is 100 .If you want to modify the parameter, pls kindly remove the cursor
to the modified bit you need, then set up the parameter via +/- keys.
B002
MPLR
T
Unit Int. M
4 30 30
47