Arjo E9X, Инструкция по эксплуатации

Страница: 14 / 68

14
Electricity
supply
Connect the mains plug to a suitable socket outlet. Make sure the plug is
easily accessible so it can be disconnected quickly in an emergency.
Fig. 3 - Power supply cord and potential equalisation terminal
When the bed is connected to the electricity supply, an indicator will light on
the Attendant Control Panel (see page 33).
The power supply cord (
1
) is fitted with a plastic hook (
2
). When not in use
or before moving the bed, clip the hook onto the head board, coil up the
cable and place it over the hook as shown.
To isolate the bed from the electricity supply, disconnect the mains plug
from the socket outlet.
A potential equalisation terminal (
3
) is located at the head end of the bed.
When other electrical equipment is within reach of the patient or caregiver,
potential differences between the equipment can be minimised by
connecting together their potential equalisation terminals.
Underbed
light
The underbed light illuminates the floor on either side of the bed.
The underbed light is always on unless the bed is in its low power state;
refer to the section “Low power mode” on page 38.
1
2
3