AZI Customer Service 800-528-7411 or 602-470-1414 Page
6
of
21
Before making any connections, verify that the power requirement shown on the remote
power supply is compatible with the AC power outlet to which the balance will be
connected.
First plug the round DIN connector into the rear panel receptacle.
Then, plug the power supply into a grounded AC outlet. Do not alter or bypass
the ground plug in any way. Doing so adversely affects the performance of the
balance.
NOTE:
Your balance must be plugged in and switched on for at least one (1) hour,
then calibrated, prior to use. Please see the calibration instructions on page 9.
The On/Off Switch
Press the ON/OFF switch and observe the turn on sequence shown below.
Figure 2 - Turn On Display Sequence
During this sequence the balance is doing an automatic systems check to verify it is
functioning properly.
**NOTE:
The clamping screw must be unlocked before turning the balance on or the
balance will not be able to complete the automatic systems check.
