Chapter 3: Configuration and commissioning
76
2X Series Installation Manual
Zones in networked control panels are considered global. If two networked
control panels each include, for example, Zone 5, then these are grouped to
create a single Zone 5 configuration within the network.
Remote zones
The control panel also considers an additional zone called remote zone (REMT)
which spans all the zones in the system outside the control panel zones range.
This virtual zone can be configured like any other zone in the system and it is
important to define output group activation requirements when the panel receives
remote alarms.
Assigning loop devices to zones
Create zones by assigning zone numbers to loop devices.
To assign a zone number to a loop device:
1. Select Field setup from the Main menu.
2. Select Loop device configuration.
3. Select the corresponding loop and device.
4. Assign a zone number to the device.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Repeat as required for each device.
If the zone number is outside the valid range determined by the corresponding
initial zone and the number of loops of the control panel, the operation does not
complete and an invalid zone number error is displayed on the LCD.
General configuration
Select the General configuration option to configure the initial zone, to configure
the initial zone for a zone LED indicator (if an optional zone indicator board is
installed), or to set a zone test or disable timeout period. Default settings are
shown in the table below.
Table 38: General zone configuration options
Option
Description
Default value
Set initial zone number Configures the initial zone for the fire system. See
“Initial zone” on page 77 for more information.
1
Assign first ZI LED to
zone
Configures the initial zone LED for an installed zone
LED indicator board. See “First zone indicator LED”
on page 77 for more information.
1
Содержание 2X Series
