Ariens 921029, Руководство владельца/оператора

Страница: 11 / 40

EN - 11
Unfold Upper Handlebar Assembly
(Figure 7)
1. Rotate the handlebar into operating
position.
NOTICE: Be careful not to damage cable
spring hooks when rotating handlebar
upward.
.
2. Install the remaining handlebar
hardware attaching the upper handlebar
assembly to the lower handlebar
(Figure 5).
3. Tighten all hardware.
4. Remove packaging around shift rod.
5. Rotate shift rod into place and tighten
hardware.
6. Connect shift rod to speed selector arm
and adjust as specified in Speed
Selector Adjustment on page 27.
7. Adjust attachment cable as specified in
Attachment Clutch/Brake Adjustment on
page 28.
8. Adjust the traction cable as specified in
Traction Drive Clutch Adjustment on
page 30.
Connect Headlight Wire Harness
(Figure 8)
NOTICE: The headlight wire harness comes
attached to the upper handlebar assembly.
1. Route the wire harness along the interior
of the right side handlebar.
2. Connect to the engine electrical plug.
3. Press cable anchor into mounting hole in
the frame near the engine electrical
plug.
4. Secure the wire harness to the
handlebars using the cable ties attached
to the wire harness.
5. Gather excess wire harness length and
fasten to handlebar with cable tie
included in literature pack.
Install Discharge Chute, Chute
Control and Chute Rod
(Figures 9, 10, 11 and 12)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from auger
housing. (Figure 9).
3. Install discharge chute over opening in
the auger housing. Put J-clamp from
deflector cable on top mounting bolt.
4. Install mounting hardware into housing
and finger tighten.
NOTICE: Leave discharge chute pedestal
loose to help install the chute rod.
Figure 7
1. Handlebar Hardware
2. Shift Rod Hardware
3. Shift Rod
4. Speed Selector Lever
1
3
2
4
Figure 8
2
4
3
1. Wire Harness
2. Cable Tie
3. Cable Anchor
4. Engine Electrical Plug
1
2