EN - 28
5. Secure adjustment pivot pin with hairpin.
6. Make sure the speed selector shifts into
each speed position.
7. Check forward and reverse speeds:
a. Start unit.
b. Shift speed selector into the first
forward speed.
c. Engage the traction drive clutch.
Unit should move forward.
d. Stop unit.
e. Shift speed selector into first
reverse speed.
f. Engage the traction drive clutch.
Unit should move backward.
g. Shut off unit.
8. Adjust pivot pin on the shift rod as
necessary so unit travels forward when
speed selector is in first forward position
and travels backward when speed
selector is in first reverse position.
9. Connect the pivot pin to the speed
selector arm with the hardware removed
in step 1.
ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
(Figures 28 and 29)
Remove Attachment Cable Slack
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Loosen hardware securing belt cover to
unit.
NOTICE:
DO NOT completely remove the
hardware from unit.
3. Remove belt cover.
4. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel down to shorten cable and
remove all cable slack. (Figure 28).
5. With the attachment clutch disengaged,
check that the attachment idler arm
lightly touches the frame (Figure 29).
6. Tighten jam nut on the adjustment
barrel.
IMPORTANT:
IMPROPER
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury. Auger/Impeller must stop
within 5 seconds when Attachment
Clutch lever is released.
Figure 27
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin
Figure 28
1. Adjustment Barrel
2. Jam Nut
