EN - 15
Check Function of Dual Handle
Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches
must
disengage. If they do not, contact your Dealer
for repairs.
Check Tire Pressure
Check tire pressure and adjust to the
pressure listed on tire sidewall.
Check Auger Gearcase Oil
Check oil level in auger gearcase (see
Check Engine Crankcase Oil
IMPORTANT:
The engine may be shipped
with oil in crankcase. Refer to Engine Manual
for detailed instructions.
Fill Engine Fuel Tank
Fill fuel tank. DO NOT OVERFILL! See
If Applicable -
remove the protective wrap
from the fuel tank and install the fuel cap
located in the attached bag.
Check Function of all Controls
Ensure unit runs and performs properly. Refer
to
Run-in Attachment Belt
1. Start unit in a well-ventilated area
2. Engage attachment clutch lever and run
attachment for about 15 minutes.
3. Stop unit, wait for all moving parts to
stop, and remove spark plug wire.
4. Adjust clutch idler according to
Attachment Clutch/Brake Adjustment
5. Adjust belt finger, if necessary. See
CAUTION:
Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment and
experience to perform the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and
tire assembly. Heat can cause an
increase in air pressure resulting in
an explosion. Welding can
structurally weaken or deform the
wheel.
• Do not stand in front or over the
tire assembly when inflating. Use a
clip-on chuck and extension hose
long enough to allow you to stand
to one side.
Figure 15
1. Round Head Square Neck Bolt
2. Skid Shoe
3. Flat Washer
4. Locking-Center Nut
